Sack abdichten nach der Füllung

Forum
13 answers in this topic
B****b
Bitte um Nachhilfe: Wenn ich 1/2 Liter Saline reinlaufen habe lasen und dann den Butterfly entferne, dann sickert aus dem Einstichloch die Saline (kein Blut!) wieder heraus
Ich habe es schon mit einem Tropfen Superkleber versucht, der wird aber "weggespült", Leukoplast hilft auch nix.
Wie dichtet ihr euren Sack ab?
Bin übrigens ab Mitte Juni in Berlin.

Ich danke euch jetzt schon für Tipps!
20
a member
versuch es mal mit Flüssig-Pflaster.
Bei mir ok aber leider kommt manchmal doch noch was aus dem Einstich
10
a member
mit Flüssig-Pflaster meine ich das Spray...... sorry
00
E*******b
ja also bei mir hat auch gar nichts geholfen. Noch nicht mal Flüssigpflaster.
Das lief manchmal die ganze Nacht noch raus.
Habe deshalb auch umgestellt auf Glucose.
Da braucht man nur die Hälfte und es hält länger.
Wichtig ist aber nach dem rausziehen ganz fest für einige Minuten mit einem Tempo oder Tupfer rauf drücken, wie nach ner Blutabnahme.
Hat auch manchmal bei Saline geklappt-allerdings sehr selten.
Und hinterher nicht gleich so viel Action mit dem Sack..grins..!!
60
B****b
Danke für die Tipps!
00
joostbear52 yrs
Sorry i reply in English, my german isn't that good.
First thing is the butterfly u use: the lower the gauge number, the thicker the needle is, It fills up much faster with a thicker gage needle, but the puncture site might take forever to close. Most people use around 22 gauge.
Second is how u puncture the skin: in angle of 90 degrees gives the smallest puncture.
Third and maybe most important is where u place the needle. The saline will accumulate in the lower half of the scrotum so if u puncture there there will be the biggest pressure on a puncture site and it will probably leak. So i always puncture at the junction between groin and scrotum,  when i remove the needle i put pressure on the function site for about 5 minutes. After that i really have to search for the spot to seal it with a drop of superglue. Works wonders!
If u put in extreme amounts of saline, there will be pressure all around and any opening could leak, but 500ml is a moderate amount and shouldn't create that that much tension in the upper part of the scrotum.
Some people even use a hairdryer to seal the glue faster but i never had to do that. Hope this helps.
10
T*******m
ich kenn das Problem, und dachte es liegt bei mir an Xarelto (Setze ich ab am Tag der Füllung), bin aber froh, dass andere das gleiche Problem haben...

Danke für die Tipps !!!!
00
B****b
thx to jostbear!
Now i think the most imprtant factor is the caliber of the butterfly.
if i use the green coded needle it is very difficult to close the hole.
better is the blue or orange coded needle.

I like to use a scrotum ring so that the saline does not rise up to the penis.

But if i wear the ring while filling it is impossible to close the puncture hole because the scrotum is very plump and laced.
so it is better first to close the puncture hole and then appy the scrotum ring...


00
joostbear52 yrs
I use the green butterfly too, that is a fine size. Remember to puncture high up on the scrotum. Never ever inflate with a ring around your scrotum, especially one made out of steel or anything that u can't release quickly!!! Can be very dangerous. So inflate without anything on, high up on scrotum and press for 5 minutes not puncture site! Good luck, shows the result please
00
M***t
Versuchs mal hiermit:

https://www.compeed.de/produkte/blasenpflaster/gross-extreme

Dichtet gut ab, hält lange bombenfest. Evtl. auch das kleinere Pflaster anwenden.

GG

TOM
00
B****b
Danke Tom für den Tipp!
00
a member
habe gute Erfahrung mit etwas Haftcreme, die man für ein Gebiss benutzt
00
U********m
am besten die einstichstelle mit zwei fingern abdrücken und so ca 5-10 min halten. die sackhaut zwischen zwei finger nehmen. ist leider etwas schwierig in worten zu beschreiben.
00
B****b
Danke stute und ballpumper!
Auf Haftcreme wäre ich nie gekommen...
Abdrücken - weiß was du meinst - ein bisserl schwierig wenn der Sack prall ist,
aber ich habe es mit "Finger drauf drücken" versucht, allerdings werden da so 5-10 Minuten ziemlich lange
Meist tu ich einen Tropfen Superkleber auf die Löcher.
00
QuoteEditDeleteRecoverRemoveMove